A 3D model of a headphone stand or an under-desk hook, made to your headphones and your desk

Example result

Example for the Standard packageShow in full

A phone stand with a cable slot for a desk at home

The model from two sides

Seen from above

Size: 80 × 85 × 87 mm, one part, about 122 cm³ of plastic. Files: a ZIP archive with model.stl and model.3mf for printing, model.obj, model.glb, outline.dxf, model.js with the sizes as named numbers (width, angle, channel for the phone) and a README. The README says to print it lying on its side with no supports, at 0.2 mm layers and 15–20% infill, in PLA or PETG.

Client: someone who wanted a stand on their desk for a phone in a thick case. Task: a stand for a phone 12 mm thick with its case, leaning back at 60°, with a lip so it does not slide and a slot for the charging cable; 80 mm wide, printed in one piece.

The client and all details are made up.

About this service

A 3D model of a holder for your headphones, to print yourself: a stand on the desk, or a hook that screws under the desk top or slides onto its edge. The headband rests on a wide, flat or gently curved saddle sized to your headphones, high enough that the ear cups do not touch the desk, and it can have a notch for the cable. You give the width of the headband where it rests, the height of the headphones, and for a hook the thickness of the desk top or your screw size. You get a ZIP archive with STL and 3MF files, OBJ, GLB, a DXF outline, the code with the sizes at the top, a README with printing advice and pictures from four sides. The shape is geometric: no figurines or sculpted forms, and no lettering or logos. It is made for headphones, and its strength is not guaranteed. We do not print or ship it.

What is included

• What you getA ZIP archive with model.stl and model.3mf to print, model.obj for 3D editors, model.glb for viewing on the web and in augmented reality, outline.dxf with the outline seen from above, model.js with the headband width and height as named numbers at the top, a README with printing advice and 4 PNG pictures from four sides, also shown on the order page.
• A rest that fitsAs wide as your headband, so the padding is not pressed into a thin edge
• On or under the deskA stand with a wide base, or a hook with screw holes or a slot for the desk edge
• Room for the cupsHigh enough for your headphones, from the height you measured
• Cable holderA notch or a small hook for the cable, if you want one
• Printing adviceWhich side down, supports, layer height, infill and material, in the README

How it works

1. 1
   SizesYou send the headband width, the headphone height and where the holder goes
2. 2
   3D modelWe build the 3D model and check that it is a closed solid of the sizes you asked for
3. 3
   CheckYou check the sizes in the pictures and the README and print it
4. 4
   ChangesYou send what to change, with measurements, within your package

What we need from you

Where it goes: on the desk, under the desk top or on the side of a shelf. In mm: the width of the headband where it rests, and the height of the headphones from the top of the band to the bottom of the ear cups. For a hook, the thickness of the desk top at the edge and how far the hook may stick out, or the size of the screws you will use. If it holds two pairs, the sizes of both. A photo of the headphones and of the desk edge with a ruler helps. The material, if you know it.

We will ask you:

• Stand or hook, and where?
• Headphone sizes in mm
• For a hook: the desk edge
• Extras
• Your printer and material

Compare packages

Questions and answers

Did not find your answer? Ask us